产品中心
新闻动态 当前位置:首页>新闻动态>新闻动态

防撞墙模具模型在使用的时候,需要使用连接杆

网址:www.fzqmoju.com.cn  2022-03-01  作者:admin    阅读:

防撞墙模具模型在使用的时候,需要使用连接杆,因为两片式的防撞墙模板无法固定在地上,所以上面、两侧面都会带有螺杆,起到固定模具的作用,顶部圆弧的装置在生产模具的时候已经焊接在上面了。防撞墙模具模型有效替代了隔离墩模具的预制作用,
When the mold model of the anti-collision wall is used, the connecting rod is needed. Because the two-piece anti-collision wall template cannot be fixed on the ground, there will be screws on the upper and two sides to fix the mold. The device of the top arc has been welded on it when the mold is produced. The mold model of the anti-collision wall effectively replaces the prefabrication function of the isolation pier mold,
可以搬运到任何公路建设上,满足了及时生产的需要,省却了中间运输隔离墩预制块的环节。模具标准件的应用将日渐广泛,模具标准化及模具标准件的应用能极大地影响模具制造周期。使用模具标准件不但能缩短模具制造周期,而且能提高模具质量和降低模具制造成本。同时,快速经济模具的前景十分广阔。由于人们要求防撞墙模具的生产周期越短越好,因此开发快速经济模具越来越引起人们的重视。防撞墙模具的原材料需要具有淬硬性。
It can be transported to any highway construction to meet the needs of timely production and save the link of intermediate transportation of isolation pier precast block. The application of mold standard parts will be more and more widely. Mold standardization and the application of mold standard parts can greatly affect the mold manufacturing cycle. The use of mold standard parts can not only shorten the mold manufacturing cycle, but also improve the mold quality and reduce the mold manufacturing cost. At the same time, the prospect of rapid economic mold is very broad. As the production cycle of the anti-collision wall mold is required to be shorter, the development of rapid and economic mold has attracted more and more attention. The raw material of the anti-collision wall mold needs to be hardened.

返回新闻

联系电话
13313028229