产品中心
新闻动态 当前位置:首页>新闻动态>新闻动态

防撞墙模具是用钢板经过各种手续加工后而完成的

网址:www.fzqmoju.com.cn  2021-12-15  作者:admin    阅读:

防撞墙模具是用钢板经过各种手续加工后而完成的,四个角都有螺栓,卡扣固定.很多情况下脱模不好,在模具的内壁图上一层机油(由于水和油是不相融的).
The anti-collision wall mold is made of steel plate after various procedures. Four corners are fixed with bolts and clasps. In many cases, demoulding is not good, and a layer of oil is put on the inner wall of the mold (because water and oil are not compatible)
混凝土的强度也会决定也会决定脱模时间,强度的不同会决定水泥凝固的速度.如果前两者没有问题,就要考虑模具的问题,模具尺寸是否符合标准,螺栓,卡扣是否固定完好.防撞墙模具标准化生产不仅可以提高模具的质量,降低成本,同时能够提高技术力量的雄厚
The strength of concrete will also determine the demoulding time, and the different strength will determine the speed of cement solidification. If there is no problem with the former two, it is necessary to consider the mold, whether the mold size meets the standard, and whether the bolts and buckles are fixed well. The standardized production of anti-collision wall mold can not only improve the quality of the mold, reduce the cost, but also improve the strength of the technical force

返回新闻

联系电话
13313028229